Relay Parameters Exclusive __exclusive__ — Fanuc Keep

By designing keep relays to be exclusive, you prevent the machine operator from accidentally turning on two conflicting logic paths simultaneously, which could cause mechanical crashes or safety hazards. Writing Exclusive Ladder Logic with Keep Relays

A single machine design might support multiple types of automation loading systems. Manual Operator Loading K0012.1: Gantry Robot Interface Active K0012.2: Bar Feeder Interface Active

While functions vary, many builders follow similar patterns for common machine operations: Typical Function Description Reference Return May force a homing sequence before automatic operation. Door Interlock Enables or bypasses safety door lock signals. ATC Configuration

Knowing these details will allow me to provide the exact bit addresses and configuration sequences for your setup. Share public link fanuc keep relay parameters exclusive

Commonly, setting K17.1 = 1 enables the I/O softkey to output PMC parameters like K relays, counters, and timers to a memory card or via RS-232.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Here are some best practices for maintaining Fanuc keep relay parameters exclusive: By designing keep relays to be exclusive, you

Two scenarios occur frequently:

When looking at a Fanuc control screen under the PMC Parameter section, you will see a grid formatted like this: K0001 How to Read the Bits

Keep relays have battery-backed, non-volatile memory. This means that the settings are retained even after the machine is powered off or during a power outage. Door Interlock Enables or bypasses safety door lock signals

Keep relays are memory addresses assigned to the letter . Unlike standard internal relays (R-addresses) which reset when the machine loses power, K-parameters retain their status (0 or 1) even after a complete control power-off.

Reserved for core system functions, such as safety circuit interfaces or bypassing specific system-level alarms. How to Access and Change Keep Relay Parameters

Operational Rule: Only one of these bits can be set to 1. Activating the Gantry and Bar Feeder simultaneously would create conflicting E-stop and door interlock signals. 3. Coolant Delivery Systems

Non-volatile internal relays backed up by battery.

Note that Fanuc lists bit 7 on the far left and bit 0 on the far right. This follows standard binary convention.