Restart your computer to finalize the system registry changes. 3. How to Program the Hytera TC-610
Are you setting up or simple radio-to-radio communication?
: Program exact transmit (TX) and receive (RX) frequencies across up to 16 channels.
To program your radio, you will need the following hardware and software components: hytera tc 610 programming software
A computer running Windows 7, 10, or 11. (Legacy software may require running the program in "Compatibility Mode" on Windows 11).
Enter your licensed frequencies.
Once your hardware is linked and the software is open, follow these steps to configure your TC-610 units. Step 1: Read Data from the Radio Restart your computer to finalize the system registry
Test each channel by keying up with another radio.
Enter your licensed operating frequencies here. Ensure the decimal point is accurate.
Select Wide (25 kHz) or Narrow (12.5 kHz) based on local regulatory compliance. Function Keys Customization : Program exact transmit (TX) and receive (RX)
After making your desired updates, you must push the new configuration profile onto the hardware.
To program a TC-610, you cannot use the radio’s buttons alone. You require a specific "trio" of tools:
Solution: Ensure the 2-pin connector is pushed entirely into the radio body. The connection on the TC-610 is intentionally tight to maintain its water and dust resistance, requiring a firm push to seat properly. Summary of Technical Specifications for Programming Specification Hytera HT610 CPS Connection Interface Hytera 2-Pin (H1 Screwed Type) Frequency Bands VHF: 136–174 MHz | UHF: 400–420 MHz or 450–470 MHz Channel Capacity 16 Channels Channel Spacing 12.5 kHz / 25 kHz
Specifically, the PC26 programming cable is generally used to connect the TC-610's audio jack to a USB port on your PC.