Yl-105 Datasheet [COMPLETE WORKFLOW]

: Delivers a stable 3.3V DC dedicated to the target transceiver socket.

for Arduino or ESP32 to start reading data from your YL-105 sensor?

Typical wiring connections for Arduino projects using the YL-105 regulator:

The YL-105 datasheet provides detailed specifications for the component, including:

: Connects to the 5V to 12V supply rail on the host microcontroller. GND : System ground connection. yl-105 datasheet

void setup() pinMode(sensorPin, INPUT_PULLUP); attachInterrupt(digitalPinToInterrupt(sensorPin), countPulse, FALLING); Serial.begin(9600);

The YL-105 is used wherever an NRF24L01 module is required in a 5V environment:

If you can describe or upload a picture (though I can't see it), or answer these questions, I can give you a :

void setup() Serial.begin(9600); // Receiver is connected to Interrupt 0 (Pin 2 on Arduino Uno) mySwitch.enableReceive(0); : Delivers a stable 3

Offers precise measurements, with typical linearity and hysteresis within ± 0.5% full scale 1.2.1.

The YL-105 simplifies hardware layout by embedding all required decoupling capacitors and voltage stabilization architecture directly onto a tiny, breadboard-friendly footprint.

: Features an active AMS1117-3.3 Low Dropout (LDO) linear regulator. Input Supply Voltage ( VCCcap V sub cap C cap C end-sub

Guide for Soil Moisture Sensor YL-69 or HL-69 with the Arduino GND : System ground connection

YL-105 Output Socket (To nRF24L01+) +---------------+ GND -| 1 (•) (•) 2 |- VCC (3.3V out) CE -| 3 (•) (•) 4 |- CSN SCK -| 5 (•) (•) 6 |- MOSI MISO -| 7 (•) (•) 8 |- IRQ +---------------+ Use code with caution. Input Pin Descriptions (To Microcontroller)

If you are interested in learning more about the YL-105 or would like to obtain a copy of the datasheet, you can visit the following resources:

: SPI standard low-active select line for bus communication.