V2000-c Rfid Access Control User Manual |best| Jun 2026

The system is now reset to factory defaults. The Master Code reverts to , and all system settings return to standard configuration. Note: User data (cards and PINs) will not be deleted during this hardware reset. Troubleshooting

For security purposes, change the default master code immediately during installation. Enter Programming Mode ( * 9999 # ). Press 0 . Enter the + # . Re-enter the New Master Code + # . Exit Programming Mode ( * ). Adding User Cards

It is highly recommended to change the default code immediately. V2000-c Rfid Access Control User Manual

Move the internal jumper (often labeled or S16 ) to pins 1-2 . Power the device on and wait for the beeps. Power off again and move the jumper back to pins 2-3 .

Understanding the technical limits ensures safe installation and reliable long-term operation. 12V DC ± 10% The system is now reset to factory defaults

Regular maintenance and upgrades are essential to ensure the V2000-C RFID access control system operates efficiently and securely. The following recommendations are provided:

The manual emphasizes the following:

While in programming mode, press then "0" then "1" .

If you forget the system password or need to restore factory settings, follow these steps: Enter the + #

Most standalone units like the V2000-C use numeric commands for management: Enter Programming Mode. Press [5] + [4-digit User ID] (e.g., 0001). Present the RFID card to the reader (you will hear a beep). Press [#] to confirm. Delete RFID Card: By Card: Press [7] + [Present Card] + [#] . By User ID: Press [6] + [4-digit User ID] + [#] . Add Public PIN: Press [3] + [4-digit Public PIN] + [#] . 4. System Settings