Xmtk-9000 User Manual Official
For RS-485 Modbus networks, ensure a 120-ohm terminating resistor is placed across the A and B lines at the physical end of the bus network. 3. Initial Setup and Configuration
: Software-amendable deviation in the range of ±2℃ (0~502℃).
| 代码 | 参数名称 | 功能说明 | 典型范围 | |------|----------|----------|----------| | | 设定值 | 目标工艺温度 | 0-400°C | | SC1 | 传感器误差修正 | 修正传感器误差 | 根据需要校准 | | P1 | 比例带 | 调整PID控制的比例增益 | 0-200 | | I1 | 积分时间 | 消除静态误差 | 0-2000秒 | | D1 | 微分时间 | 提高控制的稳定性 | 0-200秒 | | T1 | 控制周期 | 输出动作的周期 | 2-120秒 | | AT1 | 自整定 | 自动计算PID参数 | 0: 关闭, 1: 开启 | xmtk-9000 user manual
For further support:
A: Yes, select the 4–20mA current input option in the parameters. The display units will be in engineering units (e.g., psi or bar) corresponding to the transmitter’s range. For RS-485 Modbus networks, ensure a 120-ohm terminating
Connect the 24V DC positive lead to the terminal marked V+ and the ground/neutral lead to V- . Always terminate the chassis ground terminal ( PE ) to your local station earth ground.
However, the device’s complexity often overwhelms new users. This is written to replace the original 312-page technical document with a practical, task-oriented guide. Whether you need to perform initial calibration, configure Modbus RTU, or troubleshoot error code E-47 , this manual provides the answers. | 代码 | 参数名称 | 功能说明 | 典型范围
I can generate precise wiring schematics, register address maps, or step-by-step programming guidelines based on your answers. Share public link
Note: The XMTK-9000 series includes variants such as XMTK-9702, which may have additional features; refer to your specific model label.
In applications like HDPE pipe welding, a common issue is a discrepancy between the set temperature on the XMTK-9000 and the actual heating plate temperature. This drift can lead to poor fusion quality.
A: The XMTK-9000 outputs a 4–20mA or 0–10V analog signal that can regulate a variable frequency drive (VFD) or a motor speed controller, making it suitable for speed control applications.