V2ray Mikrotik Exclusive Link

Force all DNS requests to go through the proxy by redirecting UDP port 53.

/ip address add address=172.17.0.1/24 interface=dockers

Modern MikroTik routers running RouterOS v7 on ARM, ARM64, or x86 architectures support Docker-compatible containers. This allows you to run a lightweight V2Ray container directly inside the router's resources.

: The MikroTik community forum provides active threads where users share their config.json templates and solve architecture-specific errors. v2ray mikrotik

Three common deployment models:

Monitor logs ( /container/print , /container/log print ) to ensure it connects. Step 3: Configure Transparent Proxy (Redirect Traffic)

Every device in your home or office connected to the router is automatically protected, including IoT devices that don't support VPN clients. Force all DNS requests to go through the

Administrative access to the WinBox interface or RouterOS CLI.

/ip/address/add address=172.17.0.1/24 interface=bridge /ip/firewall/nat/add chain=srcnat action=masquerade src-address=172.17.0.0/24 Use code with caution. Phase 2: Deploying V2Ray/Xray Container

If your MikroTik uses an MIPSBE or MMIPS architecture (like the hEX series), it cannot run containers. You must route traffic to a secondary local device running V2Ray. Step 1: Mark the Traffic in MikroTik Mangle : The MikroTik community forum provides active threads

Handles core routing, marks specific data packets, and forwards them.

/ip route add dst-address=0.0.0.0/0 gateway=v2ray-container

Check the MikroTik logs ( /log/print ). This usually happens due to syntax errors in your config.json or incorrect path mappings in the /container/add command.