Adaptar Fuente De Pc A Ps4 Fat
Une el cable de con cualquier cable negro de la fuente de PC.
Realiza este procedimiento bajo tu propia responsabilidad. Verifica siempre las conexiones con un multímetro antes de encender la consola por primera vez para garantizar que los voltajes invertidos no dañen los circuitos integrados de la PlayStation.
The third problem was the “Deep Sleep” state. The PS4 expected a constant trickle of standby power even when “off.” The PC supply, used to hard shut-downs, kept cutting the 3.3V line, forcing the console to rebuild its database every single time he turned it on.
Antes de encender la consola, conecta la fuente de PC a la corriente corriente. El ventilador de la fuente de PC no girará de inmediato, pero la PS4 Fat debería mostrar la . Presiona el botón de encendido de la consola. En ese instante, la placa enviará la señal a través del cable verde, activando por completo la fuente de PC, encendiendo su ventilador y arrancando el sistema operativo de la PlayStation con normalidad. Ventajas y Consideraciones Importantes adaptar fuente de pc a ps4 fat
Replacing it with an original spare is straightforward, but in scenarios where an original is unavailable, too expensive, or for custom cooling projects, a PC ATX PSU can be adapted.
Luis soldered carefully. He stripped the ends of a sacrificial SATA power cable from the PC supply. He connected the green PS_ON wire from the PC’s 24-pin to the motherboard’s power-enable pin. He linked a 3.3V standby line to keep the USB ports alive for controller pairing. For the main 12V rail, he twisted two thick yellow wires together to handle the amp draw.
Al sacar la fuente de alimentación fuera del chasis de la PS4, la consola se calentará drásticamente menos, prolongando la vida útil de la APU. Une el cable de con cualquier cable negro de la fuente de PC
:
entregue como mínimo para cubrir los picos de consumo de la PS4 Fat.
- Standby): Conectar al cable de la fuente de PC (entrega constantes incluso apagada). The third problem was the “Deep Sleep” state
– the 12V rail carries high current and the motherboard can short against any metal.
| Problem | Likely Cause | Fix | |---------|--------------|-----| | Red light present, no power-on | PS_ON signal not reaching green wire | Test with multimeter: When pressing power, does PS4 output 3.3V on its PS_ON? If yes, check transistor. | | PSU shuts down after 2 seconds | No load or short | Add a dummy load (HDD or fan). Check for short between 12V and GND. | | 3.3VSB drops when power pressed | Regulator can’t supply enough current | Upgrade to a 1A LDO regulator or use a DC-DC buck converter (5V to 3.3V). | | USB ports don’t work | 5V rail missing | Confirm red wires are soldered correctly. | | Disc drive doesn’t eject | 12V not present | Check yellow wires. |
It is important to note that the maximum current a single ATX connector pin can safely carry is about 6 amps. To safely deliver the PS4's potential ~10-12A of 12V current, you must use multiple +12V and GND wires in parallel to distribute the electrical load. For example, using two +12V wires would halve the current through each.
Soldador de estaño, pasta para soldar, tubo termorretáctil (termofil), cinta aislante, multímetro y un interruptor pequeño (opcional). Pinout y Correspondencia de Cables